DIY Sanitizer Dispenser Module
- Usable with Ultra Sonic, IR Sensor, and other sensor types
- Micro controller Based Design
- Default Detection Distance: < 6 inches
- Default Trigger Time: 200 mS
- Input Voltage: 12 VDC
- Max Current Consumption: 1 A
- Output Voltage: 12 VDC
₹295.00 Incl. of GSTDIY Sanitizer Dispenser Module
₹295.00 Incl. of GSTCH376S USB Disk Read Write Module
- Supply Voltage: 5V
- Internal curing CH376S chip FAT file system, file operations simple and fast
- Support including USB thumb drives, USB hard drives, USB flash drives, and USB storage devices, USB card reader
- Compatible with CH372, host compatible with CH375
₹289.00₹306.80Incl. of GSTCH376S USB Disk Read Write Module
₹289.00₹306.80Incl. of GST
BTS7960 43A H-Bridge High-Power Motor Driver Module
- Chip: BTS7960
- Continuous Current: 43A per channel
- Operating Voltage: 5.5V – 27V
- Control Signal Voltage: 3.3V or 5V logic compatible
- PWM Frequency: Up to 25kHz
- Dimensions: Compact module for easy integration
- Protection: Overtemperature and overcurrent protection
₹278.00 Incl. of GSTBTS7960 43A H-Bridge High-Power Motor Driver Module
₹278.00 Incl. of GSTNodeMCU ESP8266 CP2102 Wifi Development Board
- Based on ESP8266-12F/12E
- Easy to use wifi development board with Lua Scripting
- Open source firmware and development kit
- Input Voltage: 5V to 12V
- Built in USB to TTL Serial using CP2102
₹270.50 Incl. of GSTNodeMCU ESP8266 CP2102 Wifi Development Board
₹270.50 Incl. of GSTPN532 NFC RFID Read Write Module Kit V3
- Operating Voltage: 3.3V – 24V (TTL level for I2C/UART), 3.3V (TTL for SPI)
- Interface: I2C, SPI, High-Speed UART (HSU)
- Communication Distance: 5cm to 7cm (NFC and RFID)
- PCB Antenna: Built-in, providing 4cm to 6cm communication range
- Works as an NFC device or RFID reader/writer
₹268.00 Incl. of GSTPN532 NFC RFID Read Write Module Kit V3
₹268.00 Incl. of GSTCC1101 RF Transceiver Module – 868Mhz
- Support FSK, GFSK, ASK / OOK and MSK
- Programmable data rate: 1.2 to 500k Baud
- Vertical Pin header (1.27mm pitch)
- Low voltage input (1.9~3.6V)
- SPI interface
- Independent 64-byte RX and TX data FIFOsCC1101 Core, 433MHz Wireless function
₹265.00 Incl. of GSTCC1101 RF Transceiver Module – 868Mhz
₹265.00 Incl. of GSTHC-05 Wireless Bluetooth Module without Base Plate
- Bluetooth protocol: Bluetooth Specification v2.0+EDR.
- UART interface with programmable baud rate
- With integrated antenna
- With edge connector
- Frequency: 2.4GHz ISM band.
- Modulation: GFSK(Gaussian Frequency Shift Keying).
- Emission power: =4dBm, Class 2.
- Sensitivity: =-84dBm at 0.1% BER.
₹264.00 Incl. of GSTHC-05 Wireless Bluetooth Module without Base Plate
₹264.00 Incl. of GSTXL6009 Step Up Module with Display
- Input Voltage: 3 ~ 32 V
- Output Voltage: 5 ~ 40V
- Transfer Efficiency: 94%
- Operating Temperature: -40°C to +85°C
- The booster works below 5V normally, but the display does not work
₹249.80₹280.84Incl. of GSTXL6009 Step Up Module with Display
₹249.80₹280.84Incl. of GSTYX850 Power Failure Automatic Switching Module – 5V-48V
- Input Voltage Range: 5V to 48V DC
- Switching Current: Up to 10A
- Power Consumption: Low power consumption during operation
- Primary-Secondary Switching Delay: < 10ms
- Operating Temperature Range: -40°C to 85°C
- Mounting: Screw hole mounting for easy installation
₹249.00 Incl. of GSTYX850 Power Failure Automatic Switching Module – 5V-48V
₹249.00 Incl. of GST125 Khz RFID Reader – EM4100 RFID Card ID Reader – 5cm Range – RDM6300
- Maximum effective distance up to 150mm
- Less than 100ms decoding time
- Support external antenna
- Support EM4100 compatible read-only or read/write tags
- Small outline design
₹239.00₹265.00Incl. of GST125 Khz RFID Reader – EM4100 RFID Card ID Reader – 5cm Range – RDM6300
₹239.00₹265.00Incl. of GSTOV2640 Camera Module with 24 pin FFC/FPC SMD Connector
- Image Sensor: OV2640, 1/4″ CMOS, 2MP (1600×1200)
- Output Resolution: UXGA / SVGA / CIF
- Output Format: JPEG, YUV, RGB565, RAW10
- Connector:
- Pre-attached 24-pin FFC cable (soldered to module)
- Included 24-pin SMD FFC/FPC connector for PCB mounting
- Operating Voltages:
- AVDD: 2.5V–3.0V
- DVDD: 1.7V–1.9V
- IOVDD: 1.7V–3.0V
- Focus: Fixed Focus
- Lens FOV: ~65°
- Frame Rate:
- UXGA (1600×1200): up to 15 fps
- SVGA (800×600): up to 30 fps
- CIF (352×288): up to 60 fps
- Power Consumption: <60 mW typical
- Operating Temperature: −20 °C to +70 °C
- Cable Type: 24-Pin 0.5 mm pitch FFC ribbon, ~60 mm length
₹238.00 Incl. of GSTOV2640 Camera Module with 24 pin FFC/FPC SMD Connector
₹238.00 Incl. of GSTESP32-WROOM-32UE-N4 – 4MB Flash – WiFi + BT + BLE Module
- CPU: ESP32-D0WD-V3 embedded, Xtensa® dual-core 32-bit LX6 microprocessor, up to 240 MHz
- Operating voltage: 3.0 ~ 3.6 V
- Wi-Fi: 802.11b/g/n
- Bluetooth: Bluetooth V4.2 BR/EDR and Bluetooth LE specification
- 40 MHz crystal oscillator
- 4 MB SPI flash
₹236.00 Incl. of GSTESP32-WROOM-32UE-N4 – 4MB Flash – WiFi + BT + BLE Module
₹236.00 Incl. of GST
Enjoy Blazing Fast Shipping on All Orders At No Extra Cost !!!