No products in the cart.
WiFi Link 5100AGN 2.4G/5G Dual frequency Adapter – Intel
- Connector interface: Mini Card form factor, based on PCIe electrical interface
- Radio ON/OFF Control: Supported in both hardware and software
- Diversity: On-board diversity support for systems designed with two antennas
- LED Output: Single WLAN-LED (as per Mini Card specification)
- Wi-Fi Alliance: Wi-Fi Certified* for 802.11 a, 802.11 b, 802.11 g, WMM*, WPA*, and WPA2*(Wi-Fi Alliance Draft-N1and 802.11n certifications expected when available)
- IEEE WLAN Standard: IEEE 802.11a/b/g/Draft-N1, 802.11d, 802.11e, 802.11i, 802.11h
₹429.00 Incl. of GSTWiFi Link 5100AGN 2.4G/5G Dual frequency Adapter – Intel
₹429.00 Incl. of GSTTB6612FNG Motor Driver Module
- Power supply voltage: VM=15V (Max.)
- Output current: Iout=1.2A (ave) / 3.2A (peak)
- Output low ON resistor: 0.5Ω (upper + lower Typ. @ VM ≥ 5V)
- Standby (Power save) system
- CW/CCW/short brake/stop function modes
- Built-in thermal shutdown circuit and low voltage detecting circuit
- Response to Pb-free packaging
₹194.00 Incl. of GSTTB6612FNG Motor Driver Module
₹194.00 Incl. of GSTTPA3110 Mono 30W Digital Amplifier Module
- Amplifier Chip: TPA3110
- Working Voltage: DC 8-26V
- Output Power: 1 x 30W
- Applicable Speaker Impedance: 4/6/8 ohm(8 ohms Best)
₹144.00 Incl. of GSTTPA3110 Mono 30W Digital Amplifier Module
₹144.00 Incl. of GSTDSO138 Oscilloscope Kit – Pre Soldered
- Mini Oscilloscope
- Max Input Voltage: 50V Peak (1x Probe)
- Max RealTime Sample Rate: 1 Msps
- Analog Bandwidth: 0 ~ 200 Khz
- Resolution: 12 Bits
- 2.4″ TFT LCD Display
- Power Supply: 9 V
₹1,698.00₹2,006.00Incl. of GSTDSO138 Oscilloscope Kit – Pre Soldered
₹1,698.00₹2,006.00Incl. of GSTR307 Fingerprint Sensor Module
- Operating voltage (v): 4.2 ~ 6 VDC
- Current consumption: ≤75mA
- Verification Speed: ~0.2 sec
- Scanning Speed: ~0.3 sec
- Character file size: 256 bytes
- Template size: 512 bytes
₹802.00 Incl. of GSTR307 Fingerprint Sensor Module
₹802.00 Incl. of GSTJT308 USB RFID Card Reader 125KHz
- Power input: USB (from a PC)
- Interface: USB, 106bit / s, no additional driver required.
- Reading distances up to 7 cm
- Frequency: 125 KHz
₹395.00 Incl. of GSTJT308 USB RFID Card Reader 125KHz
₹395.00 Incl. of GSTAutomatic Hand Sanitizer Dispenser
- Tank Capacity: 1.1 Litre
- Uses 0.5 ± 0.1 ml for each trigger
- Detection Range: 6 inch
- Easy Operation and Refill
- Small Size and light weight
All Orders will be dispatched within 1-5 days of receiving the order.
₹1,298.00 Incl. of GSTAutomatic Hand Sanitizer Dispenser
₹1,298.00 Incl. of GSTYX850 Power Failure Automatic Switching Module – 5V-48V
- Input Voltage Range: 5V to 48V DC
- Switching Current: Up to 10A
- Power Consumption: Low power consumption during operation
- Primary-Secondary Switching Delay: < 10ms
- Operating Temperature Range: -40°C to 85°C
- Mounting: Screw hole mounting for easy installation
₹249.00 Incl. of GSTYX850 Power Failure Automatic Switching Module – 5V-48V
₹249.00 Incl. of GSTMQ9 Gas Sensor Module – Carbon Monoxide, Methane and LPG Sensor Module
- Input voltage: DC 5V
- Power: 150mA
- DO output: TTL digital 0 and 1 (0.1 and 5V)
- AO output: 0.1-0.3V (relatively clean), the highest concentration voltage is about 4V.
₹128.60 Incl. of GSTMQ9 Gas Sensor Module – Carbon Monoxide, Methane and LPG Sensor Module
₹128.60 Incl. of GST13S 30A Lithium Ion BMS – 48V
- Number of cells in series: 13S
- Input Charging Current: 30A
- Output Discharging Current: 30A
- Use: 48V lithium battery
₹886.00₹1,049.02Incl. of GST13S 30A Lithium Ion BMS – 48V
₹886.00₹1,049.02Incl. of GSTSanitizer Dispenser Enclosure – 1.8 Litre
- Tank Capacity: 1.8 Ltr
- Specially designed for use as Sanitizer Dispenser Machine Enclosure
- Very less evaporation rate of Alcohol Based Sanitizer
- Easy fitment of Solenoid Valve or Pump
- Holes for Ultra Sonic sensor, and DC Plug are pre machined
₹708.00 Incl. of GSTSanitizer Dispenser Enclosure – 1.8 Litre
₹708.00 Incl. of GSTCH340C ESP32 ESP8266 USB Programmer – USB Type-C
- Chip: CH340C USB-to-Serial Converter
- Interface: USB Type-C
- Power Supply: Powered via USB connection
- Operating Voltage: 5V via USB, 3.3V regulated output for ESP32 & ESP8266
- Operating Temperature: -40°C to +85°C
₹375.00 Incl. of GSTCH340C ESP32 ESP8266 USB Programmer – USB Type-C
₹375.00 Incl. of GST