No products in the cart.
Arduino Uno R3 Compatible Board With Cable – DIP Version
- Arduino Uno DIP Version Compatible Module
- 32 KB Flash
- 2 KB SRAM
- 1 KB EEPROM
- Frequency: 16 Mhz
₹590.00 Incl. of GSTArduino Uno R3 Compatible Board With Cable – DIP Version
₹590.00 Incl. of GST
MH-M18 Wireless Bluetooth Audio Receiver Module – Bluetooth 4.2
- Model: MH-18
- Bluetooth Version: 4.2
- Operating Voltage (VDC): 3.7 ~ 5
- Max. Operating Current (mA): 20mA
- Transmission Distance: 20 Meters
₹101.50 Incl. of GSTMH-M18 Wireless Bluetooth Audio Receiver Module – Bluetooth 4.2
₹101.50 Incl. of GSTMAX7219 Dot Led Matrix Module – 8×8 MCU Control
- Driver Chip: MAX7219
- Input Voltage: 4-5.5V
- Input Current 330mA
- Requires only 3 communication wires of MCU
- A single module can drive an 8 * 8 common cathode LED
₹128.00 Incl. of GSTMAX7219 Dot Led Matrix Module – 8×8 MCU Control
₹128.00 Incl. of GSTBattery Testing Module XH-M240
- Model : XH-M240
- Display Accuracy : 0.1
- measurement accuracy : 1mAH
- Power supply : 5-12v DC
- Stand by current : 5-7 mA
- Load Power : 10W, 8ohm
₹426.00₹698.00Incl. of GSTBattery Testing Module XH-M240
₹426.00₹698.00Incl. of GSTESP32-DevKitC ESP32-WROOM-32UE Development board
- Processor: Xtensa dual-core 32-bit LX6, up to 240 MHz
- Flash Memory: 4 MB
- Wi-Fi Standard: 802.11b/g/n (2.4 GHz), up to 150 Mbps data rate
- Bluetooth: V4.2 BR/EDR and LE
- Operating Voltage: 5V
- Operating Temperature Range: -40°C to 85°C
₹510.00 Incl. of GSTESP32-DevKitC ESP32-WROOM-32UE Development board
₹510.00 Incl. of GSTGP2Y0A02YK0F Sharp Distance Measuring Sensor – 20 to 150 cm Range
- Distance Measuring Range: 20 to 150 cm
- Output Type: Analog
- Consumption Current: Typical 33 mA
- Supply Voltage: 4.5 to 5.5 V
- Operating Temperature (Topr): -10 to +60 ℃
₹425.50 Incl. of GSTGP2Y0A02YK0F Sharp Distance Measuring Sensor – 20 to 150 cm Range
₹425.50 Incl. of GSTMP4560 DC DC 8-55V to 5V 2A Step Down Module – Fixed Output
- Input Voltage (VIN): 8V to 55V
- Output Voltage (VOUT): 5V
- Output Current (IOUT): Up to 2A
- Efficiency: Up to 95%
- Quiescent Current: 140μA (typical)
- Switching Frequency: Up to 2MHz
₹180.00 Incl. of GSTMP4560 DC DC 8-55V to 5V 2A Step Down Module – Fixed Output
₹180.00 Incl. of GSTPower Bank Module – Good Quality
- Charging Voltage : DC 5V
- Charging Current:1000mA
- USB Output Current:1200mA
- Charging Interface Micro USB port
₹85.00 Incl. of GSTPower Bank Module – Good Quality
₹85.00 Incl. of GSTSolderless Sanitizer Dispenser Kit
- Solderless Sanitizer Dispenser Kit
- Easy to assemble
- Pre Programmed
- Contains all necessary items except enclosure
- Programmable as per need via onboard ISP Header
₹883.82₹1,180.00Incl. of GSTSolderless Sanitizer Dispenser Kit
₹883.82₹1,180.00Incl. of GSTWEMOS ESP32 Development Board – With Battery Holder
- Ultra-low power consumption
- 32 GPIO: ADC(16), SPI(2), I2C(1), UART(1), PWM(32), SDIO(50 Mhz)
- 520 KB SRAM
- 4 MB Flash
- 802.11BGN HT40 WiFi Transceiver (-98 dBm minimum sensitivity)
- Max data rate: 150 Mbps
- -40°C to 125°C operating temperature
₹780.00₹974.00Incl. of GSTWEMOS ESP32 Development Board – With Battery Holder
₹780.00₹974.00Incl. of GSTMQ7 Gas Sensor – Carbon Monoxide (CO)
- Circuit Voltage: 5V
- Heating Resistance: 33Ω ± 5%
- Heating consumption: About 350mW
- Relative humidity: Less than 95%RH
- Detecting range: 20ppm-2000ppm carbon monoxide
₹74.80 Incl. of GSTMQ7 Gas Sensor – Carbon Monoxide (CO)
₹74.80 Incl. of GSTTB6612FNG Motor Driver Module
- Power supply voltage: VM=15V (Max.)
- Output current: Iout=1.2A (ave) / 3.2A (peak)
- Output low ON resistor: 0.5Ω (upper + lower Typ. @ VM ≥ 5V)
- Standby (Power save) system
- CW/CCW/short brake/stop function modes
- Built-in thermal shutdown circuit and low voltage detecting circuit
- Response to Pb-free packaging
₹194.00 Incl. of GSTTB6612FNG Motor Driver Module
₹194.00 Incl. of GST