No products in the cart.
NRF24L01+PA+LNA 2.4Ghz Wireless Transceiver Module
- Supply Voltage: 3V to 3.6V
- Max Output Power: +20 dBm
- Very low power consumption
- SMA Antenna for range upto 1000 meters
- Air Data Rate : 2 MBit / s
₹168.00₹177.00Incl. of GSTNRF24L01+PA+LNA 2.4Ghz Wireless Transceiver Module
₹168.00₹177.00Incl. of GSTNRF24L01+ 2.4Ghz Wireless Transceiver Module
- Worldwide 2.4Ghz ISM Band Operation
- Common RX, TX Interface
- 126 RF Channels
- SPI Interface, easy to use with any MCU
- Very low power consumption
- Supply Voltage: 3.3V
₹64.90₹87.00Incl. of GSTNRF24L01+ 2.4Ghz Wireless Transceiver Module
₹64.90₹87.00Incl. of GSTNodeMCU ESP8266 CH340G Wifi Development Board
- Based on ESP8266-12F/12E
- Easy to use wifi development board with Lua Scripting
- Open source firmware and development kit
- Input Voltage: 5V to 14V
- In-built USB to TTL Serial Converter
- Easy to use with Node.js
₹187.00₹229.98Incl. of GSTNodeMCU ESP8266 CH340G Wifi Development Board
₹187.00₹229.98Incl. of GSTUBlox NEO 6M GPS Module with EEPROM
- Position can be updated every 12 seconds
- Cold start time of 38 s and Hot Start Time of 1 s
- Baud Rate: 4800 to 115200 (Default: 9600)
- SuperSense Indoor GPS: -162 dBm tracking sensitivity
- Supports SBAS (WAAS, EGNOS, MSAS, GAGAN)
- Comes with GPS Antenna (18 x 18 mm)
₹238.00₹292.05Incl. of GSTUBlox NEO 6M GPS Module with EEPROM
₹238.00₹292.05Incl. of GSTMT3608 Step Up Module With Micro USB – Variable Voltage
- DC to DC Variable Voltage Step Up Voltage
- Micro USB Connector for Input
- Input Voltage: 2V to 24V DC
- Output Voltage: 5V to 28V DC
- Efficiency: Max 93%
- Upto 2A Max Output Current
₹50.00 Incl. of GSTMT3608 Step Up Module With Micro USB – Variable Voltage
₹50.00 Incl. of GSTMPU6050 Module – Triple Axis Accelerometer And Gyro Module
- 3 Axis Accelerometer & 3 Axis Gyroscope sensor module
- Digital Motion Processing offloads complex MotionFusion, gesture detection etc
- Input Voltage Range: 2.4V to 3.4V DC
- I2C Digital Output of sensor data
- Digital Output Temperature sensor
₹105.00₹115.00Incl. of GSTMPU6050 Module – Triple Axis Accelerometer And Gyro Module
₹105.00₹115.00Incl. of GSTMP1584 Step Down Module
- DC to DC Switching Buck / Step Down Module
- Input Voltage Range: 4.5V to 23V DC
- Output Voltage Range: 0.8V to 20V DC
- Max Switching Frequency: 1.5 Mhz
- Low Quiescent Current
₹42.80₹56.81Incl. of GSTMP1584 Step Down Module
₹42.80₹56.81Incl. of GSTRC522 RFID Reader / Writer 13.56 Mhz Module Kit
- MFRC522 Based RFID Card Reader / Writer Kit
- Frequency: 13.56 Mhz
- Card Reading / Writing Distance: >= 50 mm
- Operating Voltage: 3.3V
₹80.00₹115.52Incl. of GSTRC522 RFID Reader / Writer 13.56 Mhz Module Kit
₹80.00₹115.52Incl. of GSTLM2596 Step Down Module – Variable Voltage
- Step Down Voltage Converter with Adjustable output
- High Build Quality
- Max Output Current: upto 3A
- Wide Input Voltage Range: 4.5V to 35V
- Wide Output Voltage Range: 3V to Input Voltage – 1.5V
₹49.00₹59.00Incl. of GSTLM2596 Step Down Module – Variable Voltage
₹49.00₹59.00Incl. of GSTLiquid Float Switch – Normally Open
- Liquid Float Switch with Washer
- Wire Length: 1 meter
- Normally Open Type Switch
- Max Current Rating: 500 mA
- Contact Rating: Max 10W
₹111.00 Incl. of GSTLiquid Float Switch – Normally Open
₹111.00 Incl. of GST4S 30A Battery Management System ( BMS ) – LifePO4
- 4S 30A BMS for LifePO4 Battery Pack
- Charging Current: 20A
- Charging Voltage: 14.8V to 18V
- Continuous Discharge Current: 30A
₹217.00₹264.32Incl. of GST4S 30A Battery Management System ( BMS ) – LifePO4
₹217.00₹264.32Incl. of GSTJLink V9 Debugger Emulator – ARM MCU Development Tool
- The main control chip adopts STM32F205, not lose firmware, and the hardware is upgraded to the latest version of V9.4
- Can provide 3.3V and 0.8A current for the development board (pin 2)
- Support standard JTAG interface and 2-wire SWD debugging interface. The speed can reach 20M (JTAG) / 15M (SWD) per second.
- Support debugging of all ARM chips, support MDK or IAR, and compile environment IDE supported by other standard JLink.
- Original firmware, full automatic upgrade The main control chip adopts STM32F205, without losing the firmware, and the hardware is upgraded to the latest version of V9.4
₹2,550.00 Incl. of GSTJLink V9 Debugger Emulator – ARM MCU Development Tool
₹2,550.00 Incl. of GST