NE5532DR IC – Dual Low Noise Operational Amplifier – SOIC-8
- Supply Voltage (VCC): ±22 V
- Input Voltage Range: ±15 V (max)
- Output Voltage Swing: ±13 V (RL > 10 kΩ)
- Slew Rate: 10 V/μs (typical)
- Input Offset Voltage: 0.5 mV typ / 5 mV max
- Input Bias Current: 30 nA typ / 500 nA max
- Make: HGSEMI
₹9.40 Incl. of GSTNE5532DR IC – Dual Low Noise Operational Amplifier – SOIC-8
₹9.40 Incl. of GSTInductor 4.7uH – SMD – JMC0603-4R7MF-A – 7×6.6×2.8 mm – JYSemi
- Inductance: 4.7 µH ± 20%
- Rated Current: 6A
- Temperature storage range: -55℃~125℃
- DC Resistance(mΩ)Max: 33
- L×W×H: 7×6.6×2.8 mm ± 0.5mm
- Part No.: JMC0603-4R7MF-A
₹9.00 Incl. of GSTInductor 4.7uH – SMD – JMC0603-4R7MF-A – 7×6.6×2.8 mm – JYSemi
₹9.00 Incl. of GSTOLED Display 1.3 inch Blue SPI – 128×64 – 7 pin
- Driver Chip: SH1106
- Interface: SPI
- Resolution: 128×64 pixels
- Display Size: 1.3 inch
- Display Color: Blue
- Pin Count: 7 pins
- Viewing Angle: Greater than 160°
- Operating Temperature: -40℃ to 80℃
- Operating Voltage: 3.3V / 5V
₹310.90 Incl. of GSTOLED Display 1.3 inch Blue SPI – 128×64 – 7 pin
₹310.90 Incl. of GSTSI7021 Temperature And Humidity Sensor Module
- Uses the I2C interface
- Typical humidity accuracy of ±2%
- Typical temperature accuracy of ±0.3C
- Operates from 0 to 100% humidity but this sensor isn’t recommended for harsh environments where it could come in contact with water (such as rain)
- 3.3V sensor – use inline logic level converters or 10kΩ resistors to limit 5V signals
- Only one Si7021 sensor can reside on the I2C bus at a time
₹631.00 Incl. of GSTSI7021 Temperature And Humidity Sensor Module
₹631.00 Incl. of GSTFFC Cable 15 pin 1mm Pitch – 100mm length – Type B
- Name: FFC (Flexible Flat Cable)
- Number of Pins: 15
- Pitch: 1mm
- Length: 100mm
- Type: B (Conductors on the opposite Side)
- Material: Polyester
- Operating Temperature: +80°C
- Voltage Rating: 60V
- Current Rating: 0.5A per pin
- Bend Radius: ≥ 5mm
₹49.00 Incl. of GSTFFC Cable 15 pin 1mm Pitch – 100mm length – Type B
₹49.00 Incl. of GST12V 2 Channel IoT Relay Module – Smart Iot Home Automation Relay
- On board high quality MCU and ESP-01 WIFI module.
- IoT Relay – can be controlled using mobile app from anywhere in the world subject to internet connectivity
- Input Voltage : 12V DC to be connected IN+ and IN-
- 2 Relays to control 2 different devices
- UART serial port PIN: 5V, GND, TX, RX.
- Reserved MCU download port: CLK, DATA, RST, GND.
- Module Status indication via LED
- Factory Reset Switch
₹699.00₹809.00Incl. of GST12V 2 Channel IoT Relay Module – Smart Iot Home Automation Relay
₹699.00₹809.00Incl. of GSTSPI BIOS FLASH Non-Dismantling Test Program Clip SOP8 24C 93C 25LF
- Supported IC Package: SOP8 (Small Outline Package, 8-pin)
- Pitch Lead: 2.54mm
- Clip Type: Spring-loaded test clip for secure contact
- Cable Type: 8-pin multi-wire cable for programmer connection
- Supports many different EEPROMS 150mil / 209mil – 24Cxx, 25Cxx, 93Cxx, 95xxx, 25Lxx
- Applications: BIOS re-flashing, EEPROM programming, and in-circuit testing
₹149.00 Incl. of GSTSPI BIOS FLASH Non-Dismantling Test Program Clip SOP8 24C 93C 25LF
₹149.00 Incl. of GSTXY2500RT 2 Pin Male Pluggable Terminal RA – 2.54mm Pitch
- Product Type: XY2500RT 2 Pin Male Pluggable Terminal
- Connector Type: Male Terminal, Pluggable
- Pitch: 2.54mm
- Orientation: Right Angle (RA)
- Number of Pins: 2 Pins
- Mounting Type: PCB horizontal mounting
- Current Rating: Typically supports up to 4A
- Voltage Rating: 150/250V AC/DC (typical)
- Operating Temperature Range: -40°C to +105°C
₹19.20 Incl. of GSTXY2500RT 2 Pin Male Pluggable Terminal RA – 2.54mm Pitch
₹19.20 Incl. of GSTBTS7960 Motor Driver IC – 43A H-Bridge – High-Power – Infineon – TO263-7
- MPN: BTS7960
- Make: Infineon
- Continuous Current: 43A per channel
- Operating Voltage: 5.5V – 27V
- Control Signal Voltage: 3.3V or 5V logic compatible
- PWM Frequency: Up to 25kHz
- Protection: Overtemperature and overcurrent protection
₹145.00 Incl. of GSTBTS7960 Motor Driver IC – 43A H-Bridge – High-Power – Infineon – TO263-7
₹145.00 Incl. of GSTBTS7960 43A H-Bridge High-Power Motor Driver Module
- Chip: BTS7960
- Continuous Current: 43A per channel
- Operating Voltage: 5.5V – 27V
- Control Signal Voltage: 3.3V or 5V logic compatible
- PWM Frequency: Up to 25kHz
- Dimensions: Compact module for easy integration
- Protection: Overtemperature and overcurrent protection
₹278.00 Incl. of GSTBTS7960 43A H-Bridge High-Power Motor Driver Module
₹278.00 Incl. of GST
