No products in the cart.
Sanitizer Dispenser Enclosure – 1.8 Litre
- Tank Capacity: 1.8 Ltr
- Specially designed for use as Sanitizer Dispenser Machine Enclosure
- Very less evaporation rate of Alcohol Based Sanitizer
- Easy fitment of Solenoid Valve or Pump
- Holes for Ultra Sonic sensor, and DC Plug are pre machined
₹708.00 Incl. of GSTSanitizer Dispenser Enclosure – 1.8 Litre
₹708.00 Incl. of GST
74HC541D SMD IC Buffers & Line Drivers- SOP20
- Logic Family: High-Speed CMOS (HC / HCT)
- Number of Inputs: 8
- Number of Outputs: 8
- Output Type: 3-State
- Supply Voltage (VCC): 2.0 V – 6.0 V
- Operating Temperature: -40°C to +125°C
- Package Type: SOP-20 / Surface Mount (SMD)
- Automotive Qualification: AEC-Q100 (Grade 1)
₹39.50 Incl. of GST74HC541D SMD IC Buffers & Line Drivers- SOP20
₹39.50 Incl. of GSTBond Solder Wire 500gm – 60/40 – 18 SWG
- Product: Solder Wire
- Composition Sn/Pb: 60/40
- Size : 1.21 mm/18 SWG
- Net Weight: 500 GM
- Flux : 2%
- Make : Bond
- Batch No, Mfg Date and Expiry Date will vary as per available stock
₹1,535.00 Incl. of GSTBond Solder Wire 500gm – 60/40 – 18 SWG
₹1,535.00 Incl. of GSTTDA2030A 6-12V 18W Audio Amplifier Module
- IC Used: TDA2030A
- Input Voltage (VIN): 6V to 12V DC
- Output Power: Up to 18W
- Audio Frequency Range: 20 Hz to 20 kHz (supports full audio spectrum)
- Harmonic Distortion: Low total harmonic distortion (THD)
- Protection Features: Over-temperature protection, short-circuit protection
- Operating Temperature Range: -20°C to +70°C
₹64.00 Incl. of GSTTDA2030A 6-12V 18W Audio Amplifier Module
₹64.00 Incl. of GSTMCP23017T-E/SO – 16-Bit I/O Expander – Microchip – SOIC-28
- Manufacturer: Microchip Technology
- Part Number: MCP23017T-E/SO
- Interface: I²C (Two-wire serial)
- Number of I/O Pins: 16 GPIO
- Operating Voltage: 1.8V to 5.5V
- Maximum I²C Speed: 1.7 MHz
- Interrupt Outputs: 2 (INTA, INTB)
- Operating Temperature: –40°C to +85°C
- Package Type: SOIC-28 (SMD)
- Logic Compatibility: 3.3V and 5V systems
₹152.00 Incl. of GSTMCP23017T-E/SO – 16-Bit I/O Expander – Microchip – SOIC-28
₹152.00 Incl. of GSTFSUSB42MUX USB2.0 Switch IC – Hi-Speed Bi-Directional UART Switch MSOP-10
- Supply Voltage (VCC): 2.4 – 4.4 V
- Control Input Voltage (SEL, OE): 0 – VCC V
- Switch I/O Voltage (VSW): −0.5 – 4.5 V
- Operating Temperature (TA): −40°C to +85°C
- High-Speed Switch On-Resistance (RON): 3.9 Ω typical @ VSW = 0.4V, ION = 8 mA (max 7.5 Ω)
- Manufacturer: ONSEMI
₹60.00 Incl. of GSTFSUSB42MUX USB2.0 Switch IC – Hi-Speed Bi-Directional UART Switch MSOP-10
₹60.00 Incl. of GST2 Channel USB Dc Dc Buck Converter Fast Charger Module QC3.0 QC2.0
- Input Voltage: 6V to 32V DC
- Output voltage: Default 5V, automatically adjust between 3-12V after triggering fast charge
- Output power: up to 24W (5V/3.4A, 9V/2.5A, 12V/2A, etc.)
- USB Ports: 2 x USB Type-A
- Conversion efficiency: 90%-97%
- Supports QC2.0, QC3.0, AFC, SFCP, FCP, BC1.2, Apple, Samsung
₹204.90 Incl. of GST2 Channel USB Dc Dc Buck Converter Fast Charger Module QC3.0 QC2.0
₹204.90 Incl. of GST12V 2 Channel IoT Relay Module – Smart Iot Home Automation Relay
- On board high quality MCU and ESP-01 WIFI module.
- IoT Relay – can be controlled using mobile app from anywhere in the world subject to internet connectivity
- Input Voltage : 12V DC to be connected IN+ and IN-
- 2 Relays to control 2 different devices
- UART serial port PIN: 5V, GND, TX, RX.
- Reserved MCU download port: CLK, DATA, RST, GND.
- Module Status indication via LED
- Factory Reset Switch
₹699.00₹809.00Incl. of GST12V 2 Channel IoT Relay Module – Smart Iot Home Automation Relay
₹699.00₹809.00Incl. of GSTSI7021 Temperature And Humidity Sensor Module
- Uses the I2C interface
- Typical humidity accuracy of ±2%
- Typical temperature accuracy of ±0.3C
- Operates from 0 to 100% humidity but this sensor isn’t recommended for harsh environments where it could come in contact with water (such as rain)
- 3.3V sensor – use inline logic level converters or 10kΩ resistors to limit 5V signals
- Only one Si7021 sensor can reside on the I2C bus at a time
₹631.00 Incl. of GSTSI7021 Temperature And Humidity Sensor Module
₹631.00 Incl. of GSTESP32-C6-WROOM-1U-N4 – WiFi 6 + BLE + Zigbee Module – Espressif
- Core: 32-bit RISC-V single-core processor
- Maximum Clock Frequency: Up to 160 MHz
- ROM: 320 KB
- SRAM: 512 KB (HP) + 16 KB (LP)
- Flash: 4 MB SPI Flash
- Wi-Fi: 2.4 GHz IEEE 802.11ax (Wi-Fi 6), backward compatible with 802.11 b/g/n
- Bluetooth: Bluetooth Low Energy (Bluetooth 5)
- IEEE 802.15.4: Zigbee 3.0, Thread 1.3
- GPIO: Up to 23 pins
- Operating Voltage: 3.0 V to 3.6 V
- Operating Temperature: -40°C to +85°C
- Antenna: External antenna connector (WROOM-1U)
₹475.00 Incl. of GSTESP32-C6-WROOM-1U-N4 – WiFi 6 + BLE + Zigbee Module – Espressif
₹475.00 Incl. of GSTMP2617BGL IC – 3A Switching Battery Charger IC Power Path Management – MPS – QFN-20
- Operating Input Voltage Range: 4.0V to 10.0V
- Switching Frequency: 1.6 MHz (Typ), with a range from 1.4 MHz to 1.8 MHz
- Input Current Limit Options: USB2.0 (450mA), USB3.0 (825mA), Default Mode (2000mA), and Programmable Mode
- Quiescent Current: Charger enabled (up to 5mA), disabled mode (3-5µA)
- SYS Output Regulation Voltage: 3.6V (Typ) for VBATT ≤ 3.4V and programmable up to 4.63V
- Package: SMD QFN-20 (3mmX4mm)
₹171.00 Incl. of GSTMP2617BGL IC – 3A Switching Battery Charger IC Power Path Management – MPS – QFN-20
₹171.00 Incl. of GSTPMS7003 Plantower Laser PM Sensor Module – Air Quality Sensor
- Sensor Model: PMS7003
- Operating Voltage: 4.5V to 5.5V
- Interface: UART (3.3V logic level)
- Range of measurement:0.3~1.0; 1.0~2.5; 2.5~10 Micrometer (um)
- Current Consumption: ≤100 mA
- Operating Temperature: -10°C to +60°C
- Manufacturer: Plantower
₹1,685.00 Incl. of GSTPMS7003 Plantower Laser PM Sensor Module – Air Quality Sensor
₹1,685.00 Incl. of GST