No products in the cart.
12V 2 Channel IoT Relay Module – Smart Iot Home Automation Relay
- On board high quality MCU and ESP-01 WIFI module.
- IoT Relay – can be controlled using mobile app from anywhere in the world subject to internet connectivity
- Input Voltage : 12V DC to be connected IN+ and IN-
- 2 Relays to control 2 different devices
- UART serial port PIN: 5V, GND, TX, RX.
- Reserved MCU download port: CLK, DATA, RST, GND.
- Module Status indication via LED
- Factory Reset Switch
₹699.00₹809.00Incl. of GST12V 2 Channel IoT Relay Module – Smart Iot Home Automation Relay
₹699.00₹809.00Incl. of GSTUltrasonic Sensor Module – HY-SRF05
- Ultra Sonic Sensor
- Detection Distance: 3cm to 400cm
- Detection Angle: Not less than 15 Degree
- Input Signal: 10uS TTL Pulse
₹118.00 Incl. of GSTUltrasonic Sensor Module – HY-SRF05
₹118.00 Incl. of GSTCR1225 Camelion 3V Battery
- Battery Type: CR1225
- Chemistry: Lithium/Manganese Dioxide (Li-MnO2)
- Voltage: 3 Volts
- Capacity: Typically around 48-50 milliampere-hours (mAh)
- Operating Temperature: Generally ranges from -20°C to +60°C
₹130.00 Incl. of GSTCR1225 Camelion 3V Battery
₹130.00 Incl. of GSTEL357N Optocoupler – SOP-4 – Everlight – EL357N(C)(TA)-G
- Input Forward Current (IF): 50 mA
- Peak Forward Current (1 μs pulse): 1 A
- Reverse Voltage (VR): 6 V
- Collector-Emitter Voltage (VCEO): 80 V
- Emitter-Collector Voltage (VECO): 7 V
- Collector Current (IC): 50 mA
- Total Power Dissipation (PTOT): 200 mW
- Operating Temperature (TOPR): -55°C to +110°C
- MPN: EL357N(C)(TA)-G
- Make: Everlight
₹14.95 Incl. of GSTEL357N Optocoupler – SOP-4 – Everlight – EL357N(C)(TA)-G
₹14.95 Incl. of GSTMale Header Pins 40×2 Smd – 1.27mm Pitch – Brass
- Number of Pins: 40 X 2 (Double row)
- Pitch: 1.27mm
- Mounting Type: Surface Mount Device (SMD)
- Material: Brass
- Pin Height: 3.7mm
- Operating Temperature Range: -40°C to +105°C
₹34.00 Incl. of GSTMale Header Pins 40×2 Smd – 1.27mm Pitch – Brass
₹34.00 Incl. of GST201 9 Pin Single Side Female Cable – 7/40 – 11 inch Length – 2mm Pitch – JST PH Compatible
- 201-9 Pin Single Side Female Cable
- Pitch: 2 mm
- Wire Gauge: 7/40
- Cable Length: 11 inch
- Compatible with JST PH 2mm
₹13.50 Incl. of GST201 10 pin Female Connector – 2mm Pitch – PH Series Compatible
- Current Rating: 2 A
- Voltage Rating: 100 V
- Pitch: 2 mm
- Pins: 10
- Type: Female Connector
- Compatible with JST PH 2mm
₹0.81 Incl. of GST201 10 pin Female Connector – 2mm Pitch – PH Series Compatible
₹0.81 Incl. of GSTIP3005A IC – Single Cell Battery Protection IC – Injoinic – eSOP8L
- Overcharge Voltage (VCU): 4V ~ 4.575V
- Overcharge Recovery Voltage (VCL): 3.85V ~ 4.4V
- Over-Discharge Voltage (VDL): 2.3V ~ 3V
- Over-Discharge Recovery Voltage (VDR): 2.4V ~ 3.1V
- Discharge Current Protection: 4A ~ 10A
- Charging Current Protection: 2A ~ 8A
- Package Type: eSOP8L with built-in power MOSFET
- Works with single cell lithium-ion and lithium-polymer batteries
₹13.95 Incl. of GSTIP3005A IC – Single Cell Battery Protection IC – Injoinic – eSOP8L
₹13.95 Incl. of GST12V 2 Channel WiFi Relay module
- Relay Channel: 2
- Input/Trigger Voltage (VDC): 12V DC
- Switching Voltage (VAC):250@10A
- Switching Voltage (VDC):30@10A
- Wireless relay module allows to control anything using mobile app
- Has Wifi And Hotstop Mode
- LEDs to indicate different modes and status of module
- Reserved UART debug interface and MCU download port for programming
- Only works when Mobile and Module connected to same wifi network
₹599.00₹660.00Incl. of GST12V 2 Channel WiFi Relay module
₹599.00₹660.00Incl. of GSTXbee Shield V03 Module
- Easy to use Arduino Shield
- I/O are compatbile with 3.3V and 5V
- Dual Power Output @ 3.3V and 5V
- Compatible with USB2.0 Protocol
- Can be coupled with Xbee Bluetooth Module, for wireless communication over bluetooth
₹147.50 Incl. of GSTXbee Shield V03 Module
₹147.50 Incl. of GST